Pioneer Home Theater System HTZ 333DVD User Manual

Setting up your DVD/CD Receiver  
When connecting this system or changing connections, be sure to switch the power off with the STANDBY/ONbutton, and disconnect the power cord from the AC outlet.  
Do not use these speakers with any other system or amplifier as this may result in damage or fire.  
Using the remote control  
Additional notes on connecting antennas  
Keep antenna cables away from the main unit and other cables.  
To assure optimum reception, pull the FM antenna so that it is  
fully extended and not coiled or hanging at the rear of the unit.  
If reception with the supplied antenna is poor, see the Other  
Check that you have all the accessories, then put  
the batteries in the remote control.  
Connect the AM and FM antennas to the rear panel of the DVD/CD receiver.  
The remote control can be used within a range of about 7  
meters from the remote sensor on the front panel, and  
within a 30 degree angle.  
2
1
Precautions:  
The remote control may not work if there is an obstacle  
between the remote control and the display unit, or if the  
remote control is not directed towards the remote sensor  
of the display unit at the correct angle.  
The remote control may not work properly if strong  
light such as direct sunlight or fluorescent light is shining  
onto the units remote sensor.  
The remote control may not work properly when this  
unit is used near devices emitting infrared rays, or when  
remote controls of other devices which use infrared rays  
are used. Also, the use of this remote control may cause  
other devices to work improperly.  
When the operating range of the remote becomes too  
short, replace the batteries.  
Batteries and  
remote control  
connections section in the main operating instructions for details  
on connecting outdoor antennas.  
Pull off the protective shields  
of both AM antenna wires.  
1
2
STANDBY/ON  
Additional notes on speaker placement  
fig. A  
fig. B  
fig. C  
CD  
FM/AM  
TUNER  
L1/L2  
LINE  
DVD  
TV  
Power cord*  
* Illustration shows the Taiwan model  
FRONT  
If your listening room is of adequate size, place the speakers as  
shown in step 3 to achieve the optimum surround sound effect. If  
you are listening in a fairly small room and a typical surround  
speaker setup is not possible, see Home theater sound setup in the  
instruction manual and the Speaker Setup guide for information on  
the Front surround 3-spot setup option.  
When using the standard surround speaker setup as shown in  
step 3, please observe the following guidelines:  
Install the main front left and right speakers at an equal  
distance from the TV.  
For optimum effect, install the rear speakers slightly above ear  
level.  
SURROUND  
OPEN CLOSE  
0
Push open the tabs, then insert  
one wire fully into each terminal.  
8
3
7
1
4
¡
4
4
DVD MENU  
RETURN  
TUNE+  
ST–  
ST+  
ENTER  
BASS  
TUNE–  
MUTE  
MODE  
Release the tabs to secure the AM  
antenna wires.  
3
4
MASTER  
VOLUME  
Video cord  
FM antenna  
6
TV CONTROL  
CH  
INPUT  
VOL  
OPEN  
1
Fix the AM loop antenna to the  
attached stand.  
Remote control battery caution  
Incorrect use of batteries may cause leakage or  
rupture.  
Always be sure to follow these guidelines:  
Always insert batteries into the battery compartment  
2
Install the center speaker above or below the TV so that the  
sound of the center channel is localized at the TV screen.  
To fix the stand to the antenna, bend in the  
direction indicated by the arrow (fig. A) then  
clip the loop onto the stand (fig. B).  
3
FM  
AM  
ANTENNA  
Precautions:  
UNBAL 75  
LOOP ANTENNA  
AM loop antenna  
When installing the center speaker on top of the TV, be sure to  
correctly matching the positive ª and negative ·  
polarities, as shown by the display inside the  
compartment.  
secure it with tape or some other suitable means. Otherwise, the  
speaker may fall from the TV due to external shocks such as  
earthquakes, endangering those nearby or damaging the speaker.  
Note: If you plan to mount the AM antenna  
to a wall or other surface, secure the stand  
with screws (fig. C) before clipping the loop  
to the stand. Make sure the reception is clear.  
Microphone  
Never mix new and used batteries.  
Batteries of the same size may have different voltages,  
Do not connect the supplied speakers with any other amplifier.  
This may result in malfunction or fire.  
The front, center and surround speakers supplied with this  
(for Auto MCACC setup)  
depending on brand. Do not mix different brands of  
batteries.  
3
1
2
system are magnetically shielded. However, depending on the  
installation location, color distortion may occur if the speaker is  
installed extremely close to the screen of a television set. If this  
happens case, turn the power switch of the television set OFF,  
and turn it ON after 15 to 30 minutes. If the problem persists,  
place the speaker system away from the television set.  
When disposing of used batteries, please comply with  
Place the AM antenna on a flat  
surface and point in the direction  
giving the best reception.  
Don’t let it come into contact with metal  
objects and avoid placing near computers,  
television sets or other electrical appliances.  
5
6
Connect the FM wire antenna to the FM UNBAL 75antenna terminal.  
For best results, extend the FM antenna fully and fix to a wall or door  
frame. Dont drape loosely or leave coiled up.  
governmental regulations or environmental public  
instruction's rules that apply in your country or area.  
In order to prevent battery leakage, remove the  
batteries when not using the remote control for an  
extended period (one month or more). If leakage occurs,  
carefully wipe away any battery fluid inside the  
The subwoofer is not magnetically shielded and so should not  
Note: The signal earth (H) is designed to reduce noise that occurs when an  
antenna is connected. It is not an electrical safety earth.  
be placed near a TV or monitor. Since it is not magnetically  
shielded, do not place any magnetic storage media (such as floppy  
disks and tape or video cassettes) close to the subwoofer.  
compartment, and replace the batteries with new ones.  
Do not allow books or other objects to rest on top of  
the remote control, since the buttons may be depressed,  
causing faster exhaustion of the batteries.  
Do not fix the subwoofer and center speaker to the wall or  
ceiling; they could cause injury if they fell.  
Connect each speaker as shown below.  
Connect each speaker using the color-coded  
speaker cords. Match them to the colored  
speaker terminals on the rear panel of the  
DVD/CD receiver.  
3
Color-coded wire  
(Connect to speaker)  
Connect the DVD/CD receiver to your TV, then connect the  
supplied power cord.  
4
Color-coded connector  
(Connect to rear panel)  
Surround right  
(Grey)  
Surround left  
(Blue)  
Connect one end to a video input on your TV.  
Use the supplied video cord.  
1
Twistandpullofftheprotective  
shields on each wire.  
1
Connect the other end to the video output of the DVD/CD receiver.  
This player is equipped with copy protection technology. Do not connect this  
player to your TV via a VCR using AV cables, as the picture from this player will not  
appear properly on your TV.  
2
* Illustration shows the Taiwan model  
Connect the wires to the  
2
IN  
IN  
OUT  
Connect the power cord to the AC inlet.  
speaker. Match the colored  
wire with the color-coded  
label (above the tabs), then  
insert the colored wire into  
the red (+) tab and the other  
wire with the black (–) tab.  
3
MCACC  
6
FRONT  
MIC  
6
CENTER  
L
Listening position  
SPEAKERS  
6
L
L
R
AUDIO  
TV  
LINE 1  
6
Subwoofer (Purple)  
R
R
VIDEO IN  
6
6
SURROUND  
SUB  
WOOFER  
Connect the other end to the color-  
3
coded speaker terminals on the  
rear of the DVD/CD receiver (as  
shown at left). Make sure to insert  
completely.  
OPTICAL IN  
IN  
IN  
IN  
OUT  
AUDIO  
MCACC  
MIC  
6
FRONT  
6
CENTER  
L
CONTROL  
LINE  
2
FM  
SPEAKERS  
L
6
L
ANTENNA  
UNBAL
COMPONENT  
VIDEO OUT  
R
Y
TV AUDIO LINE  
1
P
B
R
6
R
R
Center (Green)  
6
6
AC IN  
SURROUND  
SUB  
P
VIDEO  
OUT  
VIDEO  
OUT  
S-VIDEO  
OUT  
WOOFER  
VIDEO  
VIDEO  
Upper three terminals  
Front left  
(White)  
Front right  
(Red)  
The small lug at the wire-end of the  
speaker plug should face up or  
down depending on whether it's  
being plugged into one of the  
upper or lower three speaker  
terminals. Please make sure to  
connect correctly.  
* Illustration shows  
the Taiwan model  
AC IN  
For the best surround sound, setup your speakers  
as above. The front left and right speakers should  
be about 1.8–2.7 m apart.  
ToACoutlet  
These speaker terminals can be hazardous when live. When you connect or  
disconnect the speaker cables, to prevent the risk of electric shock, do not  
touch uninsulated parts before disconnecting the power cord.  
Congratulations! You're done setting up.  
Lower three terminals  
Printed in  
<XRE3099-A>  
Speaker Setup guide  
Chooseyoursubwooferplacement(Taiwanmodelonly)  
Check that you have all the speaker accessories.  
The subwoofer supplied with this  
system can be placed upright or on  
its side (flat). Choose the position  
that works best for your room, then  
attach the large non-skid pads as  
shown at right.  
Flat position  
Upright position  
• Front speakers x 2  
• Center speaker x 1  
• Surround speakers x 2  
• Subwoofer x 1  
• Speaker cords x 6  
Front left (White) Center (Green)  
Front right (Red)  
• Non-skid pads (large)  
Taiwanmodel x4  
All other models x 6  
• Mounting brackets x 4 *  
Subwoofer (Purple)  
Surround left  
(Blue)  
Surround right  
(Grey)  
Taiwan model  
All other models  
• Non-skid pads (small) x 12  
• Screws (for mounting brackets) x 4 *  
* Please refer to Wall-mounting the front and surround speaker system in the operating instructions for installation.  
Attach the smaller non-skid pads to the base of each of  
Connect the speaker system.  
Refer to Setting up your DVD/CD Receiver  
(the other part of this setup guide) to  
connect the speakers properly. Place  
them as shown in the diagram at far left  
for optimal surround sound.  
Standard surround  
5-spot setup  
Attach the large non-skid pads to the base of the subwoofer  
1
2
the front and center speakers.  
(Singapore/Indonesia/Hong Kong/Phillipines/Malaysia models)  
Use the adhesive to attach 4 pads to the base of each speaker.  
This is a standard multichannel surround  
sound speaker setup for optimal 5.1  
channel home theater sound.  
Use the supplied adhesive to attach 6  
pads to the base of subwoofer.  
: Non-skid pads  
Subwoofer  
Front left  
Front right  
Center  
Surround  
left  
Surround  
right  
Front speakers  
Center speaker  
Listening position  
* Illustration shows the Taiwan model  
Turn the surround speakers towards the closest wall, lining the arrows up  
Attach the smaller non-skid pads  
to the base of each of the front  
Connect the speaker system.  
Refer to Setting up your DVD/CD  
Receiver (the other part of this setup  
guide) to connect the speakers properly.  
Place them as shown in the diagram at  
far left for optimal surround sound.  
Front surround  
3-spot setup  
1
4
2
3
for optimal Front Surround.  
Turn each surround speaker so that the arrow at the base is lined up with the FRONT  
SURROUND arrow on the front speaker. This is only necessary with the FrtMovie or FrtMusic  
modes. With ExtPower (Extra Power), line up the arrow with the EXTRA POWER arrow  
(the surround speakers should be in the same direction as the front speakers). See the  
operating instructions for more on the Front Surround modes.  
and center speakers.  
This setup is ideal when rear surround speaker  
placement isn’t possible or you want to avoid  
running long speaker cables in your listening area.  
Use the adhesive to attach 4 pads to the  
base of each speaker.  
The base of each surround speaker fits  
into the circular groove on the top of the  
front speakers as shown.  
Front speakers  
Surround  
left  
Surround  
right  
Front  
left  
Front  
right  
Center  
Subwoofer  
Secure the speaker wire.  
After testing for the slack necessary to  
turn the speaker (see the following  
step), use the groove provided to secure  
the speaker wire as shown.  
Leave 5 cm of slack from the speaker  
terminals so the upper (surround)  
speaker can turn freely.  
Caution  
To prevent accidents, make sure the  
surround speaker is placed securely  
on top of the front speaker.  
Please don't attach the speakers to  
the wall or speaker stands for Front  
surround 3-spot setup.  
Listening position  
* Illustration shows the Taiwan model  
Center speaker  
ExtPower  
FrtMovie / FrtMusic  
 

Pelco Home Security System C3610m a1 08 User Manual
Pelco Stereo Receiver WX8000 User Manual
Philips Universal Remote SRU2040 User Manual
Polycom Cell Phone 300 and 310 User Manual
Poulan Trimmer 530164149 User Manual
Powermate Portable Generator P2201 User Manual
Powermatic Saw PM1800 User Manual
Prince Castle Oven DHB 34 User Manual
PVI Industries Water Heater 40 P 90A MXG User Manual
PYLE Audio Car Stereo System PLAD3300D User Manual